2023 FORD, F550 SD, Medium Duty Trucks - Service Trucks / Utility Trucks / Mechanic Trucks, FORD 6.7L POWER STROKE, Automatic, THIS MAINTAINER SERVICE BODY WITH H7024ST-1-84 CRANE IS ON THE GROUND AND AVAILABLE! GIVE US A CALL TODAY! THIS ONE WON'T LAST LONG! THE CHASSIS HAS A SNOW PLOW PREP PACKAGE AND HIGH CAPACITY TRAILER TOW PACKAGE. THIS SERVICE TRUCK FEATURES THE FOLLOWING: 1-ton, 52" tall compartments, 44" x 21" wheel well opening with skirting, front body bulkhead, body access grab handles, painted safety yellow (locations and number to vary with design) (11.083) Feet of Service Body - 1-ton, 52" tall Galvannealed compartments with reinforced floors, clean out drains, 3/16"Aluminum doors with automotive door seals, three point D-ring door latches and gas spring door holders and 14 Gauge Deck Plate. Factory Installation of body on a chassis. Short Tower Crane reinforcement for MTS 1 or 2 ton service body (up to 45,100 ft*Lbs.) Crane Location : Curb Side --- Hydraulic Power Package --- Open center hydraulic power package with high pressure filter. NOTE: The Open-Center hydraulic system allows operation of only a single hydraulic component at a time. Multi-component operation requires a Closed-Center system and is not available on some chassis configurations. Contact factory for details. Open center hydraulic system pump (Chelsea) includes pressure reducer Oil reservoir - complete #028013, composite 28 gallons; Tank only, excluding oil (28) Hydraulic Oil (Standard oil, per gallon) Oil good for -25° F startup and 9° F to 187° F operating temperature --- Welder / Generator / Inverter / Power Equipment --- Miller Bobcat 260 gas (Kohler) #907792, with GFCI outlets, remote start / stop NOTE: 28"H (33"H to exhaust) x 20"W x40.5"D / 501 Lbs.. Mounting angles, 45 long. Includes mounting holes for common accessories. --- Air Compressor Equipment & Accessories --- VMAC H40 rotary screw hydraulic driven air compressor w/ white cover (Open-Center). 40 CFM @ 150 psi with integral hydraulic oil cooler. Includes control panel, mounted near body's switch panel & Hydraulic Soft Start. Note: Hydraulic requirement = 14 GPM (May require large pump kit, not included). Cold weather package included (cooler bypass), additional oil warming valve available (open center only) (24"L x 16.5"W x 18"H) 162 Lbs. Mounting angles for Air Compressor Air tank - 17 gallon - (Pressure rating of 200 psi) / 16" diameter, Includes moisture drain, Painted Black Air accessory package - 1/2" X 50', spring rewind reel, hose & ball stop 1/2" Filter, Regulator, and Lubricator (FRL) Fiber box; Hose reel access, Limit 1 Reel Per Fiber box Air Compressor Controls mounted in Non standard Compartment (Street Side Vertical #1 is Standard) - -- Outriggers & Accessories --- Outriggers for cranes up to 45,100 ft*Lbs., hydraulic up/down rear outriggers (2) with hydraulic extend in/out on crane side (30" extend) Outri
